- ALL HOUSE CODE version - Can transmit and receive all 256 addresses!
- Status Response*
- X10 RF Receiver 433MHz
- Built-in Appliance Module (Address 1), rated at 5amps
Yes, at last an X10 RF gateway that allows reception and re-transmission of all 256 X10 addresses (House Code A-P, and Addresses 1-16).
When the TM13's House Code is set to position 'P' it will forward any House Code it receives! (When the TM13 is set as House Code between A-O it will only respond to that House Code, setting to House Code P allows All House Code control).
If you plan to use an RF transmitter like an SS13, an MS13, or a KR19 then you also need the TM13 which receives the radio waves (RF) and then transmits X10 down the mains line to an awaiting X10 receiver module, like an
AM12,
LM12,
LW10 or
AW10
When set to House Code P, the built-in Appliance Module will always respond when Address 1 is sent (A1, B1, etc will all command the built-in Appliance Module). When set to a House Code other than P, it will respond only when it
receives it's own House Code on Address 1 (if the TM13 is set to House Code A, then only A1 will make the TM13's Appliance Module respond).
*If
