|
 
|
Wire In Lamp Module LM12W | |
| |
Wire In Lamp Module | £17.00
|
| |
| You can use thesemodules to remotely control ceiling lights, by wiring in the module near the ceiling rose, in the ceiling.
The Lamp Module can be used with lamps up a maximum rating of 300W. The Lamp Module is dimmable. Use the Appliance Module for higher rated lights. The Appliance Module can switch loads of up to 13 Amps.
Use in conjunction with an X10 transmitter like a IR7243 , HomeVision , CM12U , Mini Timer , Maxi Controller , Mini Controller , or SM10 . You can also use an RF based solution ( HR10 , All-in-one remote , MS13 , KR19 , or SS13 ) as long as you also have a TM13 RF Receiver module.
These units must be mounted within an enclosure to comply with electrical regulations.
Technical Data (LM12W)
Supply voltage: 230 V +/-10% 50 Hz
Supply current: 20 mA capacitive
Making capacity: 60 to 300 W (incandescent, and 12 V halogen lamps only)
Regulating time: 4,4 sec +/- 0.2sec from fully on to off
EMC emission: According to EN 50081-1
EMC immunity: According to EN 50082-1
Electrical safety: According to EN 60950 and EN 60065
Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz
Input impedance: 55 W (L - N) at 120 kHz
Ambient temperature: - 10 degrees C to + 50 degrees C (operation)
- 20 degrees C to + 70 degrees C (storage)
|
| | |
| Payment Methods |
| American Express, MasterCard, Visa, Solo, Delta, Switch, Maestro, Visa Electron, Cheque |
|
